We are attempting to connect a GVP box via Dialogic to a Siemens HiCom 300 switch. We have it configured as T1-Robbed bit on the GVP side and have tried both loop start and wink start in the VPM configuration, with no luck. Does anybody out there have a configuration for both the GVP side and the Siemens side that they would be willing to share?
Thanks!
Ross Hartford
Hi,
I don’t have Dialogic with our GVP (we use SIP), but if it will help you, I can email you our GVP config.
Vic
Well we got it working. Below is the Siemens switch configuration. BTW, use the pdk_us_ls_fxs_io configuration in the VPM setup.
| DETAILS OF TMD BOARD AT ADDRESS (LTG.LTU.SLOT) = z. y. xx
| |
| CABTYP = 3 TIMTYP = SYST SIGTYP = CAS
| FRAME = STD TABS = NO FCTID = 1
| BI8SUB = NO BIVDET = NO |
|---|
| RDRATIO = 6 RDTH = 2500 RDQUAL = 15000 |
| YLSEND = 5000 YLTH = 400 YLQUAL = 100 |
| LOS = 150 AOS = 4000 |
| SESDISTH = 10 SESREQTH = 10 |
| OESDISTH = 30 OESDISIN = 24-00-00 |
| OESREQTH = 4 OESREQIN = 04-00-00 |
| ------------------------------------------------------------- |
| NETUSR = ACKTIM = DLVTIM = |
| OCTMAX = RETMAX = WINDOW = |
| CRIDC = TTSC = NSFIV = |
| NSFTSC = PFDGT = |
| ------------------------------------------------------------ |
| IGN = IID = |